MVC3002-4001 CONVERTEAM

Model: MVC3002-4001
Brand: Converteam (ALSTOM/GE Power Conversion lineage)
Series: MV3000 / ALSPA MV3000 Delta
Core Function: User signal interfacing between plant and CDC controller
Type: User I/O Termination Panel
Key Specs: 50-way ribbon cable connection to controller, terminal blocks for analog/digital I/O, supports standard MV3000e control signals

Converteam MVC3002-4001 is the user I/O termination panel for ALSPA MV3000 Delta drive systems. It provides screw terminals for connecting plant signals—analog references, start/stop commands, status feedbacks, faults—to the Common Drive Controller (CDC like MVC3001-4003).

Mount it near the controller for short ribbon cable runs. Handles standard MV3000e I/O: typically analog in/out for speed/torque, digital for control, relays for alarms. Kit includes the panel, 50-way ribbon, clamp/base. In legacy setups (wind, pumps, industrial), it centralizes field wiring to avoid direct controller exposure. Discontinued—GE/Avid Controls license parts; confirm wiring diagram from T1689/T1693 before install, especially if swapping in air vs liquid-cooled configs.

Interfaces all user I/O signals reliably via ribbon to CDC—reduces wiring errors in cubicle builds
Test report provided: serial/label check, visual (no corrosion, terminal damage, dust), continuity mapping on all terminals, ribbon connection verify, 24-hour powered bench with sim signals and photos
Clear upgrade path—mounts same as original; ribbon kit ensures plug-compatible link to MVC3001 CDC
Not recommended for standalone use—requires MV3000 CDC and drive modules; migrate to newer GE converters for full system support
Supports full MV3000 I/O suite per technical manuals (analog ±10 V/4-20 mA, digital 24 V typical)
Insulation/continuity >10 MΩ at 500 V where applicable; full verification with setup photos and terminal map

Frequently Asked Questions

What does the MVC3002-4001 do in an MV3000 Delta system? It’s the termination point for all external user signals (analog speed ref, digital start/stop, fault relays) wired to screw terminals, then ribbon-linked to the CDC controller. Keeps field wiring organized away from the main controller board.

Can I install this as a direct replacement in an existing MV3000 setup? Yes—same footprint and ribbon interface. Photograph existing ribbon routing, terminal labels, and wiring before disconnect. Mount close to CDC per datasheet; test continuity end-to-end on arrival before powering up.

What’s included with the MVC3002-4001 panel? Panel itself, one 50-way ribbon cable, cable clamp/base, and data sheet. No other cables or power supplies—refer to T1689/T1693 for full system connections.

Is this new surplus or refurbished? Condition: New Surplus (New Original, not refurbished). From OEM excess or decommissioned spares—no field exposure.