MVME5110-226×500MHZ MOTOROLA

Product Core Brief

Model: MVME5110-226 (500 MHz variant)
Brand: Motorola
Series: MVME5100 PowerPlus II VME SBCs
Core Function: Powers VME64x systems at 500 MHz with PMC I/O scaling
Type: 6U single-slot VME processor module
Key Specs: MPC750 500 MHz; 512 MB ECC SDRAM; dual Ethernet
Condition: New Original (New Surplus)

Product Introduction

Motorola MVME5110-226 hits 500 MHz on MPC750 in a VME64x single board computer. PMC slots grow I/O for automation backplanes.

512 MB ECC SDRAM feeds 582 MB/s reads—burst writes top 640 MB/s. Dual 10/100 Ethernet links SCADA clean. PowerPlus II ASIC? Balances PCI without starving CPU—though PMC power adds up quick.

Installation & Configuration Guide

Phase 1 — Pre-Installation (est. 10 min)
Cut rack power. Discharge 5 min. Fluke 115, ESD gear, camera set. Export VxWorks. Shoot jumpers, cables, full view.

Phase 2 — Removal (est. 5 min)
Label leads. Pop VME latch. Pull level—no twist. Pins ok?

Phase 3 — Installation (est. 10 min)
Wrist strap clicks. Confirm 226 marking. Jumpers from photos (120 Ω ends). Seat—latch firm. 0.5 N·m wires. Check volts.

Phase 4 — Power-On & Testing (est. 15 min)
5 V ±5% good. LEDs: green RUN, red FAIL. Ethernet pings x2. Boot image. I/O loops 30 min. Log filed.

Troubleshooting quick-reference
No net? Duplex mismatch, cable test, IP static.
FAIL on? Flash reload serial.
PMC dark? PCI PRI jumper, 33 MHz lock.