Description
Product Introduction
Technical positioning — the KONGSBERG RDO-16 is a remote digital output module designed for vessel automation, alarm handling, propulsion support systems, and distributed machinery control. You’ll commonly find this unit inside K-Chief marine automation cabinets where reliable relay switching matters more than cosmetic hardware features.
Built around redundant CANopen 4.0 communication, the module provides 16 relay output channels with onboard watchdog diagnostics and status indication. In offshore deployments, the relay architecture handles inductive loads surprisingly well — though proper suppression on solenoids still matters. The unit supports direct installation near engines and auxiliary machinery while maintaining stable communication across redundant fieldbus networks.
Installation & Configuration Guide
Phase 1 — Pre-Installation (est. 10 min)
- Isolate all cabinet power sources.
- Wait minimum 5 minutes for discharge.
- Required tools: Fluke 115 multimeter, insulated torque screwdriver, ESD wrist strap.
- Export existing automation parameters first.
- Photograph relay assignments, CAN node settings, shield grounding, and output wiring. Photo. Photo. Photo.
Phase 2 — Removal (est. 5 min)
- Label every output wire before disconnecting.
- Remove CAN connectors carefully; avoid twisting the shield braid.
- Pull module perpendicular to mounting surface.
- Inspect terminals for oxidation, loose ferrules, or salt contamination. Marine cabinets age hard.
Phase 3 — Installation (est. 10 min)
- Wear ESD protection before handling the module.
- Verify exact part number and hardware revision.
- Replicate CAN addressing and termination settings from photos.
- Mount securely with even screw torque.
- Reconnect relay wiring and verify suppression devices on inductive loads.
Phase 4 — Power-On & Testing (est. 15 min)
- Confirm incoming supply remains within 24 V DC ±10%.
- Observe module LEDs:
- Green = RUN
- Red = FAULT
- Amber = CAN communication activity
- Establish communication with K-Chief or host controller.
- Trigger all relay outputs individually under test conditions.
- Operate continuously for >30 minutes while checking relay temperature rise and communication stability.
- Record firmware revision and maintenance activity.
FIREYE MED4 MicroM DAUGHTER BOARD W/DISPLAY OUTPUT.RRST
Fireye Programmer Module Flame Monitor EP-170 EP170
FIREYE PROGRAMMING CONTROL 26RJ8 MODEL 6080D
FIREYE UVM2A30 (UVM-2A-30) FLAME BURNER CONTROL NEW
FIREYE EP160, EP-160 PROGRAMMER MODULE FOR USE W/ E110
FIREYE MED6 MicroM DAUGHTER BOARD W/DISP OTP/REMRST/COM
AB Fireye Flame-Monitor EB-700 EB700 EP170 EUVS4
FIREYE 70D20 BURNER CONTROL W/ MOUNT IR AMP PROGRAMMER
FIREYE UVM-IF
Fireye Automatic Primary Safety Control
New FIREYE 70D20 CONTROL CHASIS BURNER AND COVER
FIREYE 60-1386-2
FIREYE MED5 MicroM DAUGHTER BOARD W/DISPLAY OUTPUT/COMM
Fireye Modernization Adapter 60-2060-16,
FIREYE ED400 REMOTE DISPLAY HOUSING KIT
