Product Core Brief

• Model: RET650 1KHL160055R0001A
• Brand: ABB
• Series: Relion® 650 Series
• Core Function: Transformer differential protection and bay control
• Type: Numerical protection relay / IED
• Key Specs: IEC 61850 support; 24–250 V supply; differential + backup protection
• Condition: New Original (New Surplus), not refurbished
  

  Product Introduction

  A transformer trip that should have cleared in milliseconds but instead escalated into winding damage is usually traced back to protection settings, CT saturation behavior, or firmware mismatch. ABB RET650 1KHL160055R0001A is built for transformer differential protection in utility substations, industrial power systems, and high-availability process plants.

  In field retrofits, this relay is commonly selected when engineers need IEC 61850 integration without replacing the whole protection architecture. Typical applications include two-winding and three-winding transformers, generator-transformer blocks, and reactor protection. Sub-cycle fault response below 15 ms is typical depending on configuration and CT quality; always verify the exact project file and firmware revision before commissioning.

• 

•  Key Selling Points & Differentiators

  • ABB RET650 1KHL160055R0001A supports transformer differential, overcurrent, voltage, frequency, and backup protection functions in one IED platform.
  • Native IEC 61850, GOOSE, and sampled values support reduces copper wiring in digital substations and simplifies bay integration.
  • Typical internal fault trip performance is below 15 ms when configured correctly with matched CT ratios and synchronized measurements.
  • Every tested spare should pass incoming inspection, serial/label verification, power-on diagnostics, communication handshake checks, and continuous load testing before shipment. Test reports with photos or startup video should be available on request.
  • Compared with older electromechanical transformer relays, this unit provides disturbance recording, SOE logs, firmware traceability, and remote engineering through PCM600.
  • Not recommended for direct drop-in replacement without checking firmware compatibility, binary I/O mapping, CT polarity, and existing IEC 61850 datasets.